Page 1 of 1
Implementing reaction interface on a COBIA Unit
Posted:
10 September 2021, 12:53by ahmedsabriz
Greetings Dr Jasper and fellow developers,
I could nit find the Chemical Reactions interface specifications consistent with Thermo 1.1 or any mention to the interfaces in COBIA reference documents. Is it not possible yet to develop a reactor unit using COBIA SDK?
Re: Implementing reaction interface on a COBIA Unit
Posted:
12 September 2021, 09:10by jasper
The chemical reactions interface is part of CAPE-OPEN 1.0 and has not been ported into COBIA, in favour of the new reaction interface, considered to be part of CAPE-OPEN 1.1; this unforunately is not published yet. The answer is therefore: it will be possible, but not yet.
Re: Implementing reaction interface on a COBIA Unit
Posted:
12 September 2021, 11:40by ahmedsabriz
Thanks as always for your reply. Is there a timeline for the Reactions 1.1 specifications and integration into COBIA?
Re: Implementing reaction interface on a COBIA Unit
Posted:
22 September 2021, 14:30by jasper
The request for comments (RFC) on the specification will go out in a matter of days, hopefully. After that it will still take a bit for it to get published and implemented.
Re: Implementing reaction interface on a COBIA Unit
Posted:
16 October 2021, 11:39by colancto
You may want to check with the representative of POLIMI in CO-LaN for a copy of the draft interface specification for Chemical Reactions. He has access to it. Your review, in light of your requirements for use, could be useful to CO-LaN.