CAPE-OPEN

Thanks for all of the completed work necessary to launch this new version! I am looking forward to using some of the enhanced features listed.

I installed the new version via CUP 2.6.0.0 today and am responding to report a potential oversight.
The installation began by installing ChemSep LITE 6v96, then during the COCO V2.6 installation I decided to refuse to install ChemSep LITE 6v95. I thought why overwrite the latest version with a previous version. Was this a good choice or is ChemSep LITE 6v96 being recalled and replaced with the earlier version?

ps. my screen showed COCO V2.60 during the download while your posting shows COCO V2.06. Is there a difference?

Thank you for posting your findings.

The COCO installer does not do a version check on the Chemsep installer, it just launches the installer that it has aboard which is the latest one at the time of release. The ChemSep installer used to warn about newer versions being complimented with older versions, but now allows for two versions to be installed simultaneously.

I will make a note of it an do a version check for the next COCO installer.

COCO 2.6 and COCO 2.06 are the same. Nothing should say COCO 2.60. Where during download did you see this?

All components of COCO are 2.6, or 2.06, for the first two numbers of the version. Typically the third number remains zero and the fourth number shows the revision.

Since version 1.13, the revision for each component can be matched against the change log