by nrgeng » 12 June 2015, 13:26
I have emailed a sharable fsd file, that demonstrates the problem, for your review.
COFE 2.7.0.23 Problem
My environment shows two sets of File Command Icons: New, Open, & Save
Stream Mapping Problem
Inner Flowsheet:
Within the inner T1# Flowsheet, it solves with two outlet streams from IC-17
Both Streams 42 & 43 are outlet streams
The External Ports dialog shows internal Stream 43 (as an inlet stream) connected to external stream [42y] 43y
Outer Flowsheet:
Within the outer T3# Flowsheet, the tail of Stream 43x will not connect (as it should) {Try it} to Unit Fake
Stream 43y does connect to Unit Fake with its head (error)
Unit Fake validates & calculates but does not solve (this is a problem too)
The error message is "incomplete or invalid specification for unit Fake:
External port "43" is not connected (connect from external simulation environment, or connect internally)"
Hopefully you can resolve these problems with this information.
Last edited by
nrgeng on 13 June 2015, 14:27, edited 1 time in total.